Army Corps of Engineers Under the revised requirements of CEGS-01451, Contractor Quality Control, it is mandatory that this course be successfully completed to be approved as the contractor’s quality control manager. Course certificates are valid for five years from date of successful completion. Course Description The training is formatted in the following eight modules of instruction: Introduction, Contractor’s Review, Quality Management Planning, Pre-construction Conference and Coordination meeting, Submittals, Quality Management During Construction, Making the System Work, and The Resident Management System. Class Information Cost: Member $219 Non-member $299 Location: AGC Center, Wilsonville 2018 Schedule February 23 March 30 June 1 June 29 July 27 August 31 September 28 October 26 November 30 Registration form Cancellation by Participant/Attendee There is a $25 cancellation fee for all class registrations. The customer has one week (five business days) prior to the start date of the selected class to cancel the registration entirely or transfer to another class. To clarify, if the class is on Tuesday, you must cancel by the Monday of the week before the class. If cancellation occurs within one week of the class (five business days or less), the customer may 1) replace the canceled registrant with a substitute, or 2) forfeit the registration fee. No-shows for any class will not be refunded and will be required to re-register and pay for any additional classes. All funds must be paid before the first day of any given class in order to guarantee class placement. Cancellation Due to Inclement Weather In the event of bad weather and unsafe road conditions, the class may have to be cancelled and rescheduled. Please call the AGC office, 503-682-3363 or 800-826-6610 the morning of the class and listen to the recording for additional information. Related Resources 24-Hour Fall Protection This 24-hour course is designed to meet OSHA and EM-385-1-1-2014 regulations and is mandatory if awarded an Army Corps project. Check out our scheduled classes throughout the year. » 8-Hour Confined Space Entry This course addresses numerous types of direct-reading instruments, including their mode of operation and limitations of each type, and will effectively address the requirements of 29 CFR 1926 Subpart AA, OAR 437-002-0146 and WAC 296-809 for confined space entry. Take a look. » 8-Hour Scaffold Training This class will cover how to use and inspect scaffolds as well as an overview of the scaffold requirements for both OSHA and Washington. It is designed to satisfy the requirements of the EM-385-1-1-2014. See what dates are available. » Need more information? Contact Judy Robinson for more information.